Tina version 10
Mixed Mode Simulation

Mixed Mode Simulation (Spice - VHDL - MCU co-simulation)

TINA version 8 and above include a new powerful mixed mode simulation engine. It is based on the XSPICE mixed mode algorithm, extended with MCU and VHDL components. In your circuits you may freely mix any analog or digital components of TINA, including microcontrollers (MCUs) and macros with Spice or VHDL content. You can modify these components on the fly along with the code in the MCUs. TINA will analyze the analog parts in analog, the digital parts in digital, and will automatically create the interfaces among the components. This ensures synchronization and fast convergence.

Let’s explore some of the uses of this mode through a few examples.

 

Waveform generation with VHDL and Spice subcircuits

The following circut generates an analog sine or sawtooth signal depending on the status of the left SW-MODE switch.

Tina mixed mode

The Digital Wave box on the left of the circuit includes VHDL code with a lookup table (Sine_LUT ) for the sine wave and a counter for the sawtooth signal. The essential part of the VHDL code is:

   process(Reset, Clk)
   begin
        if (Reset = '1') then
               Wave <= (others => '0');
               LUT_index <= 0;
   elsif rising_edge(Clk) then
   if (Enable = '0') then
     Wave <= (others => '0');
   elsif (Sel = '0') then
     Wave <= Sine_LUT(LUT_index);
       else
         Wave <= conv_std_logic_vector(LUT_index,5);
       end if;

       if (LUT_index = LUT_index_max) then
         LUT_index <= 0;
       else
         LUT_index <= LUT_index + 1;
       end if;

   end if;
   end process;
   d0 <= Wave(0); d1 <= Wave(1); d2 <= Wave(2); d3 <= Wave(3); d4 <= Wave(4);

The digital output of the counter is converted into an analog signal in the 5 bit DA converter of TINA shown in the middle of the circuit.

The DAC sine wave output needs to be cleaned up with a low pass filter. We will use a Spice opamp model of the TL081 in a Sallen and Key low pass filter configuration. Press the Enter Macro button on the property dialog and TINA will open the macro. You can review and, if necessary, modify the Spice code inside the macro.

Here are the final waveforms of the full circuit, including the five counter output waveforms. SW_MODE is in the High state, selecting the sawtooth signal.
 

If we change the SW-MODE switch to Low and run Transient analysis again, the waveforms are:
 

To see the effect of the analog filter, delete curves d0 to d4 from the diagram by clicking the curves and pressing the Del key.
 

 

MCU controlled SMPS circuit

The mixed mode simulator of TINA not only allows MCUs, but also any linear or nonlinear parts in TINA’s libraries. As an example, let’s study the following circuit, which realizes a DC-DC converter, converting 5V DC to 13V DC, and operating in boost mode.

The waveforms below demonstrate how the analog parts and the MCU interact in TINA.
 

 

Mixed circuit example consisting of simple analog and digital components

mixed circuit

Mixed Mode Circuit

 

You can display the results in one diagram or as separate diagrams shown below by simply appending a colon ( : ) and  a number to each output name.

mixed circuit result

Mixed mode results

Copyright © 2014DesignSoft, Inc. All rights reserved.
Designsoft RSS
Designsoft accepted cards