The Complete Electronics Lab
  • Analog,Digital,Mixed,RF, Symbolic simulation
  • Spice,HDL and S-parameter models
  • VHDL,Verilog,Verilog-A & AMS, SystemC
  • MCU simulation in mixed circuits
  • Monte-Carlo,Worst Case & Stress Analysis
  • AC & Transient Noise Analysis
  • Interactive simulation and animation
  • Virtual Instruments
  • Remote measurements
  • Distance Teaching & Learning
Tina 10 slideshow
  • Upload your designs to TINACLOUD
  • Run anywhere on any platforms
  • Download projects from TINACloud to PC
TinaCloud slideshow
Mixed HDL Simulation
  • VHDL, Verilog, SystemC
  • VHDL and Verilog Debugger
  • Verilog-A and Verilog-AMS
  • Spice & HDL in same Circuit
Tina VHDL slideshow
  • Use in office and at home
  • Use while you are mobile
  • Educational site licenses
  • Industrial site licenses
Tina student slideshow
  • MCU simulation in digital and mixed circuits
  • Hex, ASM, C, Flowchart programming
  • Hex, ASM, C, Flowchart Debugger
  • PIC, AVR, ARM, XMC, 8051, over 800 MCUs
Tina spice mcu slideshow
  • Fast multi-core analysis
  • Large number of SMPS devices
  • DC, AC and Transient Analysis
  • Startup, Input and load step
Tina SMPS slideshow
Free Trial What's new in TINACloud? What's new in TINACloud? What is TINACloud? What is TINACloud? Buy TINACloud AccessBuy TINACloud Access Buy TINA with FREE TINACloud access!Buy TINA with FREE TINACloud access!

Login TinaCloud

Stress Analysis

Stress Analysis can check parts for stress conditions such as maximum power dissipation and maximum voltage and current limits. You can set these parameters in the property window of the parts or in the catalog. This kind of analysis is also called Smoke analysis, because overloaded parts often emit smoke.

You can also run Stress Analysis by setting the Stress Analysis Enabled checkbox in the Analysis | Option dialog or on the Analysis menu.

When running DC or Transient Analysis from the Analysis menu, a list of components will appear, along with the parameters exceeding maximum limits.

If you click a component in the list, the corresponding component on the schematic diagram will be selected and turned red.

The maximum values of the components can be set in the component property dialogs or in the component catalog parameter dialogs. Both can be entered by double-clicking on the components. Before running an analysis, check and set the maximum values of the components in your circuit.


Stress Analysis

Click the picture to run this circuit online with TINACloud





TINA - Circuit Simulator for Analog, RF, Digital, MCU, HDL & Mixed Circuit Simulation and PCB Design
Copyright © 2016DesignSoft, Inc. All rights reserved.