Live 3D Breadboard

Live 3D Breadboard

Jump to TINA Main Page & General Information 

Using the Live 3D Breadboard tool in TINA, you can automatically build a life-like 3D picture of a solderless breadboard.

When you run TINA in interactive mode, components like switches, LEDs, instruments, etc. become “live” and will work on the virtual breadboard just as in reality.

You can use this capability of TINA to prepare and document lab experiments.

You can either assemble the circuit step-by-step or by generating the whole circuit on the breadboard.

Pick up and move parts on the breadboard using the mouse, and TINA will automatically rearrange the wiring while retaining connectivity.

In the same fashion, you can select and move wires for clearer appearance.

Note that you cannot change the endpoints of a wire this way–wiring integrity is preserved.

Live 3D Breadboard, image 1

The breadboard tool is mostly intended for educational purposes to prepare laboratory experiments in a safe 3D environment.

You can also use this tool to guide you in actually wiring a PCB board for lab verification, with the 3D viewer available the PCB Designer of TINA.

If you turn the PCB upside down (by holding down the left mouse button over an unused area and moving the mouse), you can see the connections of the wires from the PCB solder side to the oscilloscope.

If you use connectors instead of soldering wires directly to the PCB, you can connect the instruments through those.

By adding Header2 and Header3 (they can be found under the Connectors button on the Switches component toolbar), you can make the interconnection shown on the picture.

    X
    Glad to have you at DesignSoft
    Lets chat if need any help finding the right product or need support.
    wpChatIcon