Documentation

Documentation

Jump to TINA Main Page & General Information 

Manuals, Brochures, Requirements and other information

TINA Design Suite v12 Manuals in PDF Format

TINA Design Suite v11 Manuals in PDF Format

TINACloud Users Manual in PDF Format

Brochures in PDF format

These brochures and any part of them can be  freely used for any purpose with reference to DesignSoft and the related products.

TINA Minimum Hardware and Software Requirements

  • Intel Pentium or equivalent processor
  • 1 GB of RAM
  • 1 GB of available hard disk space
  • CD-ROM (if delivered on CD)
  • Mouse
  • VGA adapter card and monitor
  • For 3D breadboard and PCB preview hardware OpenGL is suggested, but not required
  • Operating System: Microsoft XP / Windows 7 / Windows 8 / Windows 10
  • Supported Networks (for Network versions):  MS Windows 2000/2003/2008/2012 Server or later, Novell Netware version 3.12 or later, Linux with Samba file server for SMB clients, Citrix Presentation Server If the program is copy protected by a hardware key (dongle), the minimum hardware configuration includes also a USB port

LabXplorer: Multifunction Instrument for Education and Training

TINALab II PC Instrument Specification

FPGA Development Kit

Analog Measurements

Set of 10 measurements on plug-in PCBs:

RC lowpass filterBaxandall tone-controller
Active lowpass filterClass B amplifier
Three-stage transistor amplifierCommon emitter amplifier stage
Differential-input amplifierRIAA – corrector
Butterfly tone-controllerFull-wave bridged (Graetz) rectifier

Digital Measurements

Set of 10 measurements on plug-in PCBs:

Circuit configuration of TTL gatesFlip-flops I.
Operation of TTL gatesFlip-flops II.
2-bit binary comparatorAsynchronous 4-bit binary / decade counter
Adder and Substractor Circuits4-bit binary counter
MultiplexerParallel-load 4-bit shift register

Plug-in PCB card (test card) interface

Test Card Interface.doc

Training and examination